| PNC | Part code | Title | Quantity | Information |
i |
|---|
| 1 | | NUT (M6 x 1.9) | | |
| 2 | | AIR CLEANER | | |
| 3 | | MOTOR, Air Cleaner Diaphragm | | |
| 4 | | HOSE (3/4") | | |
| 5 | | PIPE, C/Case Vent | | |
| 6 | | GROMMET, C/Case Vent Conn | | |
| 7 | | TUBE, Carb Air Preheat | | |
| 8 | | ELBOW, Deceleration Valve Hose to A/Cl | | |
| 9 | | SCREW (M6 x 1 x 20) | | |
| 10 | | CLAMP, Adjust (1/2" to 1") | | |
| 11 | | PIPE, Pulsair | | |
| 12 | | WASHER, Flat (M10) | | |
| 13 | | NUT, Hex (M10 x 1.5) | | |
| 14 | | NUT, Hex (M6 x 1.5) | | |
| 15 | | BRACKET, Pulsair Asm to Cyl Head | | |
| 16 | | SCREW (M6.3 x 1.8 x 12) | | |
| 17 | | BRACKET, Enrichment & Part Throttle | | |
| 17 | | SWITCH, Part Throttle Vac (W/Male Conn-Black & White) | | |
| 17 | | SWITCH, Enrichment Vac (W/Female Conn-Natural) | | |
| 18 | | PULSAIR | | |
| 19 | | SOLENOID, Distr Vac | | |
| 20 | | VALVE, Deceleration | | |
| 21 | | ADAPTER, Carb to Intake Manif | | |
| 22 | | GASKET, EGR Valve | | |
| 23 | | VALVE, EGR | | |
| 24 | | GASKET, Adapter | | |
| 25 | | HARNESS, Closed Loop | | |
| 26 | | CONTROLLER, Carb | | |
| 26 | | CALIBRATOR, Carb Controller | | |
| 27 | | BOLT, W/Clip, Module Brkt (9.667) | | |
| 28 | | BRACKET, Control Module-LH | | |
| 29 | | NUT "U" (M4.2 x 1.41) | | |
| 30 | | SCREW (M4.2 x 1.41 x 13) | | |
| 31 | | NUT (M5 x 0.8) | | |
| 32 | | WIRE, Closed Loop I/P Jumper | | |
| 33 | | SUPPRESSOR, Noise Modulator | | |
| 34 | | WIRE, Warning Lamp Jumper | | |
| 35 | | SCREW (M4.2 x 1.41 x 20) | | |
| 36 | | BRACKET, Control Unit-Upr ("X") | | |
| 37 | | SENSOR, Oxygen | | |
| 38 | | BRACKET, Control Unit-Lwr ("X") | | |
| 39 | | SCREW (M4.2 x 1.41 x 13) | | |
| 40 | | NUT, Nylon | | |
| 41 | | STUD, Shroud to Manifold | | |
| 42 | | SHROUD, W/Adapter, Preheater | | |
| 43 | | SCREW (M4.2 x 1.41 x 20) | | |
| 44 | | DUCT, Air Intake-Rear | | |
| 45 | | ADAPTER, Air Intake Duct-Rear | | |
| 46 | | HOSE, Air | | |
| 47 | | DUCT, Air Induction-Front | | |
| 48 | | STRAP, Wire Harness | | |
| 49 | | CLIP, Wire Harness | | |
| 50 | | WASHER, Ext Lock (7/16") | | |
| 51 | | SCREW (M10 x 1.5 x 16) | | |
| 52 | | BRACKET, Induction Duct Mtg | | |
| 53 | | SCREW (1/4"-14 x 3/4") | | |
| 54 | | ADAPTER, Air Induction-Rear | | |
| 55 | | CLAMP, Hose | | |
| 56 | | VALVE, Fuel Vapor Press Control | | |
| 57 | | CANISTER, Fuel Vapor | | |
| 58 | | CLIP, Canister | | |
| 59 | | HARNESS, Evap Emission (Incl #56) | | |
| 60 | | HARNESS, Emission Cont Vacuum Hose (Complete) | | |
| 60 | | TEE, Conn (3/16" Dia) | | |
| 60 | | CAP, Port (5/32" Fitting-Rubber) | | |
| 60 | | VALVE, Vac Hose Harn (In-Line) | | |
| 60 | | VALVE, Emission Vacuum | | |
| 60 | | TEE, Vac Hose (3/16" x 3/16" x 3/16") | | |
| 60 | | CONNECTOR, Carb Control Hose | | |
| 60 | | VALVE, Emiss Vac Hose (4 Ports) | | |
| 60 | | TEE, Vac Reg to Source (3/16" x 3/16" x 1/4") | | |
| 61 | | SWITCH, Thermal Vac Distributor | | |
| 62 | | VALVE, EGR Control | | |
| 63 | | GROMMET, Crankcase Vent | | |
| 64 | | VALVE, Crankcase Vent | | |
| 65 | | HOSE, C/Case Vent Valve to Carb | | |
| 66 | | GROMMET, C/Case Vent Pipe (3/4" ID x 1 1/4" OD) | | |
| 67 | | CONNECTOR, Hose | | |
| 68 | | VALVE, Carb Vac Break | | |
| 69 | | RETAINER, Vac Switch | | |
